10 x cleaning actions (Deep clean, brilliant shine, fresh scent, eliminates lime scale, destroys soap scum, fights everyday grime, helps remove mold & mildew stains, foaming action, great surfaces coverage, versatile usage). Kills 99.9% of viruses & bacteria (Kills 99.9% of Escherichia coli 0157:H7, rhinovirus type 39, staphylococcus aureus, pseudomonas aeruginosa, salmonella enterica and rotavirus WA on hard non-porous surfaces). Shower, sink, tub, toilet bowl exterior. Powers through tough soap scum. Destroy soap scum. Tough on mold & mildew. Cleans to a brilliant shine. Sanitize bathroom surfaces in 30 seconds (Kills 99.9% of Enterobacter aerogenes and staphylococcus aureus on hard, non-porous surfaces in 30 seconds). Shower doors. Tubs and glazed ceramic tile. Vanity tops sinks & chrome fixtures. Physical and chemical hazards: Contents under pressure. Do not use or store near heat or open flame. Do not puncture or incinerate container. Exposure to temperature above 120 degrees F or in sun or discarding can in fire or incinerator may cause bursting. Important fact: Contains no phosphates. Health. Hygiene. Home. www.rbnainfo.com. Contact Number: Questions? Comments or in case of an emergency, call toll free 1-800-228-4722. Have the product container or label with you when calling a poison control center, or doctor, or going for treatment. Questions? Call 1-800-228-4722. For ingredient and other information. www.rbnainfo.com. Encourage your local authorities to establish a program to recycle this can. This can is made from an average of 25% recycled steel (10% post-consumer). Please recycle when empty.

Other Ingredients: 99.900%, Total: 100.000%

To clean:

Shake well before using

Point button to mark on rim

Hold can 6-8 inches from surface

Spray entire surface with foam

Wipe off with a clean cloth or sponge

To clean soap scum:

Allow product to sit 15-20 seconds to penetrate soil before wiping clean

Repeat if necessary

To sanitize / disinfect:

Pre-clean surface. Spray surface until covered with foam.

To sanitize:

Leave for 30 seconds before wiping.

To disinfect:

Leave for 10 minutes before wiping.

To control the growth of mold and mildew:

Apply to pre-cleaned surface.

Let surface remain wet for 3 minutes before wiping.

Repeat application at weekly intervals or when mold and mildew growth appears. Does not harm most bathroom surfaces. For other surfaces, spot test in an inconspicuous area.